Eni Oken tutorial - Fat-wrap bead.pdf - ►Bizuteria - parys90

Page: 1

Tutorial 007: Fat-wrap bead

By Eni Oken - www.oken3d.com/jewelry

This tutorial does a review on the traditional

wrapped bead and shows you how to create a

much nicely designed alternative: the "fat-

wrap". Start by reviewing the traditional

"wrapped bead":

Step 1: Wrap one loop

For this kind of wrap, a 26 or 24 gauge can be

used. A bead was inserted on to the wire and a

loop wrapped on one end. The wire cutter was

used to cut the wire flush to the wrap.

Step 2: Wrap the other side

Using the round-nose pliers, wrap the other

side, coiling tightly as near the bead. Cut flush

with the flat part of the wire cutter.

Simple enough, right!

Although this method seems pretty

straightforward, there are ways to improve on

the design of this well-worn bead wrap.

Page: 2

Review the design

Even though so simple and well known, this

method of wrapping a single bead with a

single wire can be improved. The first step is

to analyze the design. Stylistically speaking,

there are a few problems with this type of wrap

which could be improved:

a) The loops are generally too large, resulting

in "mickey ears" around the bead. To improve,

loops should be made as small as possible.

b) The wraps near the bead are too thin to

function as caps. There is no finishing or trim to

the bead. To improve, add caps or washer type

beads.

The loops were made smaller and silver Bali

beads were added, functioning as caps. Hoever,

the Bali beads make the whole piece look too

ornamental, which may not be suitable for

contemporary designs.

Solution: The ornamental washers were

subsituted for more contemporary washers

with clean designed. A completely different

look from review #1, however, still dependent

on washers or other external beads.

Page: 3

Solution:

To become independent of washers, you can

use a triple overlapping wrap on each side.

Step 1: Start by wrapping a loop using the

round-nosed pliers. While keeping the loop still

hooked on to the pliers, wrap the wire like you

normally would towards the bead.

Step 2: Instead of cutting the wire, continue

wrapping, this time over the previous wrap,

towards the direction of the nose of the pliers.

Step 3: Wrap again , this time overlapping the

two previous wraps, towards the bead. This

forms three layers of wraps.

Page: 4

Step 4: Cut the wire flush and wrap the other

side, wrapping very closely to the bead. Be sure

to make the loop (eye) about the same distance

of the bead as the first one.

Step 5: Overlap the other side forming a thick

wrap. To make it easier to hide the wire end,

wrap very closely to the bead on the final layer

and cut flush with the wire cutters.

Step 6: Using the flat-nose pliers, straighten out

the loops. If needed, use the tip of the chain-nose

pliers to tuck in the ends of the wires. Be careful

to not squash the fat ends.

Analysis: The wraps are now thicker, making the

bead look more finished, without the need of using

washers.

Back to Techniques

Eni Oken tutorial - Fat-wrap bead.pdf

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: