DGN1000 Firmware Version 1.1.00.41.pdf

DGN1000 Firmware Version 1.1.00.41 (For

Worldwide users Only)

Note: We recommend you to update your wireless drivers to the latest version available from

wireless chipset vendor.

New Features

 Added Wifi Schedule translation

 Improved Wifi Schedule GUI.

Bug Fixes

 Port forwarding for HTTP does not work when remote management is enabled.

 The router doesn't log the event that the wan interface connection is broken.

 Wireless settings: set SSID begin with space key, in router status,the SSID displayed

without space key.

 Wireless settings: when mode is up to 150Mbps, DUT using channel bonding, but in

router status, the channel only displayed one channel instead of bonding channel.

 Sometimes I have to click "Disconnect" button several times to disconnect PPPOA

connection.

 DUT cannot log UPnP event, DHCP event and Blocked Sites events with Trusted IP.

 Email title is not accurate.

 Address Reservation does not work.

 LAN setup: when set RIP direction as NONE, DUT still learn routes from other RIP

neigbhour.

 LAN setup: when set RIP direction as NONE, DUT still learn routes from other

router.

 LAN setup: when set RIP direction as IN only, and set RIP version as RIP-2M, DUT

still learn routes from RIP-1 router.

 LAN Setup: when DUT's RIP version is RIP-2M, direction is Out only, DUT still

learns route from RIP-1 router.

To Upgrade

1. Download the firmware image using the button below, and save it to a

convenient folder such as your desktop.

The default administration URL is http://192.168.0.1 . The default username

is admin and password is password .

2. Under Maintenance , click on Router Upgrade .

3. Click Browse and locate the firmware upgrade image file (.img) you just

downloaded.

4. Click Upload to start the upgrade. Wait for the upgrade progress bar to

complete and final prompt to appear.

Do not interrupt the router upgrade process.

If you witness any problem after the firmware upgrade, it is recommended to

reset the router configuration by pressing the Factory Defaults push-button on

the rear panel until the Test LED blinks (about 10 seconds). Then re-enter your

configuration information manually.

This product includes software code developed by third parties, including software code subject to the GNU General Public License ("GPL") or GNU

Lesser General Public License ("LGPL"). As applicable, the terms of the GPL and LGPL, and information on obtaining access to the GPL Code and

LGPL Code used in this product, are available to you at NETGEAR's Open Source Code Web page . The GPL Code and LGPL Code used in this

product is distributed WITHOUT ANY WARRANTY and is subject to the copyrights of one or more authors. For details, see the GPL Code and

LGPL Code for this product and the terms of the GPL and LGPL.

Updated 10/08/2011 05:20 PM

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: