SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONSALFA ROMEO156[1].pdf

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS

www.cobra.it

MAKE ALFA ROMEO MOD.

156

YEAR 00 ﬁ

PETROL

DIESEL

ALARM/SIREN

POSITION

Position the compact alarms and the sirens behind the left or right lateral headlamp, it

depends on the vehicle version.

CENTRAL UNIT POSITION

The modular systems and the modules should be positioned under the dashboard, driver’s

side.

POWER SUPPLY

+30: connect to the general supply wiring at the entrance of the fuse box.

-31: connect directly to the car body.

IGNITION WIRE

+15/54: connect to the RED/ORANGE wire located in the 20 way white connector in the

front part of the fuse box. Alternatively, in the wiring harness located under the sill cover,

driver’s side.

DIRECTION INDICATORS

Connect to the 1 mm 2 LIGHT BLUE wire in the 20 way white connector and LIGHT

BLUE/BLACK in the 12 way connector. These connectors are located in the front part of the

fuse box, under the dashboard, drivers side. Alternatively in the wiring harness under the sill

cover, driver’s side.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the BROWN/WHITE wire.

Front window, passenger’s side:

cut the VIOLET/WHITE wire.

Connections must be done in the wiring harness coming out of the connector of the

centrallocated behind the glove compartment, passenger’s side.

Rear window, driver’s side: cut the YELLOW/RED wire.

Rear window, passenger’s side : cut the LIGHT BLUE/GREEN.

Connections must be done in the wiring harness under the sill cover, driver’s side.

CENTRAL DOORS LOCKING

Negative control signal

Connect to the 1 mm 2 WHITE wire (lock) and LIGHT BLUE (unlock). These wires are in the

wiring harness and coming out of the right connector of the central door locking unit located

at the rear right side of the glove compartment; alternatively in the wiring harness located in

the sill cover, driver’s side.

IMMOBILISATION POINT 1

Gasoil pump

Cut the BLACK/VIOLET wire coming out of the wiring harness of the inertial switch located

under the driver’s side seat.

IMMOBILISATION POINT 2

Cut the ORANGE wire in a connector coming out of the central engine plant located under

the dash board, passenger’s side.

STARTER

+50 : Cut the 2 mm 2 RED/BLACK wire located in the wiring harness coming out of the

connector of the ignition key.

BONNET SWITCH

Install an additional switch on the front headlamp support grill, driver’s side.

DOORS SWITCH

Connect to the WHITE/BLUE wire located in the black connector under the left side of the

dashboard near the handle of the bonnet. Alternatively, in the wiring harness under the sill

cover, driver’s side.

BOOT SWITCH

Connect to the 1 mm 2 RED wire located in the connector mentioned above; alternatively in

the wiring harness located in the sill cover, driver’s side.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

al15600gbd.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: