SA9.398GBB.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

SAAB

9.3

YEAR 98 ﬁ

PETROL

DIESEL

MAKE

MOD.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens in the space between the battery and the wing.

To pass the cables use the original rubber sleeve located near the support of the shock

absorber, passenger’s side.

POWER SUPPLY

+ 30: connect to the 4 mm 2 RED wire located in the wiring harness coming out of the black

multiway connector in the fuse box.

- 31: connect with a terminal to an original power supply located behind the left lateral

bulkhead, driver’s side.

IGNITION WIRE

+ 15/54: connect to the 1,5 mm 2 BLACK/GREEN wire located in the wiring harness coming

out of the grey connector behind the left lateral bulkhead, driver’s side.

DIRECTION INDICATORS

Connect to the 1,5 mm 2 GREEN/BLACK and GREY/BLACK wires located in the wiring

harness coming out of the 4th connector starting from the bottom, behind the left lateral

bulkhead, driver’s side.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the BLACK/WHITE wire located at the position nr.19.

Front window, passenger’s side:

cut the LIGHT BLUE/ WHITE wire located at the position nr.17.

Rear window, passenger’s side:

cut the GREEN/RED wire located at the position nr.14.

Rear window, passenger’s side:

cut the LIGHT BLUE/GREEN wire located at the position nr.2.

These connections are made directly on the coming out of the respective original switches

located in the central tunnel.

CENTRAL DOORS LOCKING Negative control signal

Connect to the LIGHT BLUE/BROWN wire at the position nr.8 (unlock) and RED/VIOLET wire

at the position nr.58 (lock) located in the wiring harness coming out of the connector of the

doors central unit under the front seat, driver’s side.

IMMOBILISATION POINT

Fuel pump

Cut the YELLOW/GREY wire at the position nr.16 of the connector located under the driver’s

seat.

STARTER

+50: Cut the YELLOW wire in the wiring harness coming out of the grey relè located on the

relè holder plate under the dashboard, driver’s side.

BONNET SWITCH

Install an additional switch on the headlamp support plate, near the original rubber trim of the

bonnet, driver’s side.

DOORS SWITCH

Connect to the following wires using 4 diodes to separate the lines: GREY/GREEN at the

position nr.61, BLACK/GREEN at the position nr.12, BLACK/GREEN at the position nr.60 and

BLACK/GREEN located in the central line between the two GREEN/BLACK wires in the

wiring harness coming out of the connector of the doors central unit under the driver’s seat.

BOOT SWITCH

Connect to the BLACK wire located near the GREEN/BLACK wire in the wiring harness

coming out of the connector of the central unit under the driver’s seat.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

sa9.398gbb.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: