745 2003 petrol YES.pdf

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

BMW

745i*

YEAR 03 ﬁ

PETROL

DIESEL

MAKE

MOD.

* Models with original keyless entry system.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens on the wheelhouse, passenger’s side.

CENTRAL UNIT POSITION

Position the modular sistems and the modules under, on the left of the dashboard, driver’s

side.

POWER SUPPLY

+30: connect directly to the pin coming out of the battery terminal. It is suggested such

connection as some connections with fixed supply are deactivated by the electronic system of

the vehicle after about 30 min. from the extinction of the switchboard.

-31: connect directly with a cable terminal directly to the ground terminal located behind the

driver’s side sill cover.

IGNITION WIRE

+15/54: connect to the BLACK/RED wire, at the position nr. 19 coming out of the 32 way black

connector of the “battery cut out” central, in the passenger’s side boot.

DIRECTION INDICATORS

Connect to the wires: BLUE/GREEN pos. nr.4 for the driver’s side front door, BLUE/BROWN

pos. nr.1 for the passenger’s side rear door, BLUE/BROWN pos. nr.24 for the passenger’s

side front door, BLUE/GREEN pos. nr.55 for the driver’s side rear door, located in the 88 way

black connector on the coming out of the lights operating central located on the left of the

steering column. It is suggested to separate the lines by means of 4 diodes.

ELECTRIC WINDOWS

Comfort control

The windows and electric sunroof locking is obtained by means of the original radiocontrol.

ACTIVAT./DEACTIVATION

Connections antitheft/vehicle

CONTROLS

Position

In the post. Central

car body

pos. nr.1, 88 way black connector (direct. indic.)

car body

Refer to the A diagram in the dedicated installations manual, inside the kit of the antitheft.

Vehicle

WHITE 1mm 2

BLUE 1mm 2

ground

BLUE/BROWN

ground

IMMOBILISATION POINT

Fuel pump

It is suggested to cut the fuel/gasoil pump control wire as it could create interferences in the

diagnosis of the vehicle.

STARTER

+50: Cut the 0,5mm 2 BLUE/BLACK wire at the position nr.34 in the little connector coming out

of the central marked DB7 (Motronic) positioned inside of a tinned box located in the lower part

of the antipollen, in the engine compartment.

BONNET SWITCH

Connect to the wire coming out of the lamp directly in the engine cover.

DOORS SWITCH

NOTE: the polarity is positive. Invert the signal with an additional relay. Connect to the

RED/BLUE wire coming out of the lamp of the driver’s side rudder pedals.

BOOT SWITCH

Connect to the wire coming out of the connector of the rear lamp.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

bm74503gbbt.doc

Art.3800

GREY/BLACK

YELLOW/BLACK

VIOLET/WHITE

VIOLET

ORANGE

ORANGE/WHITE

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: