FIBRO01GBBT.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

FIAT

MOD. BRAVO* YEAR 01 ﬁ

PETROL

DIESEL

MAKE

* Models with original equipment keyless entry system.

ALARM/SIREN

POSITION

Position the compact alarms and the sirens on the support of the servobrake in the

engine compartment.

CENTRAL UNIT

Position the modular systems and the modules under the dashboard, driver’s side.

POWER SUPPLY

+ 30: connect to the 4 mm 2 RED wire located in the 2 way white connector in the

fuse box.

- 31: connect directly to the car body.

IGNITION WIRE

+ 15/54: connect to the 1,5 mm 2 ORANGE wire located in the wiring harness and

coming out of the ignition key, alternatively to the 1mm 2 BLUE/RED wire located in

the multiway connector in the fuse box.

DIRECTION INDICATORS

Connect to the LIGHT BLUE and LIGHT BLUE/BLACK wires in the 4 way white

connector on the original blinker push botton.

ELECTRIC WINDOWS

Positive control signal

Front window, driver’s side:

cut the VIOLET/YELLOW wire at the position nr. 8, in the 20 way white connector

on the ABI central located behind the glove compartment, passenger’s side.

Front window, passenger’s side:

cut the VIOLET/WHITE wire at the position nr. 9, in the 20 way white connector on

the ABI central located behind the glove compartment, passenger’s side.

ACTIVAT./DEACTIVATION

CONTROLS

Connections antitheft/vehicle

Art.3800 Vehicle Position

YELLOW/BLACK Pos. nr.1 8 way connector

GREY/BLACK Positive

VIOLET Positive

ORANGE Positive

VIOLET/WHITE Positive

ORANGE/WHITE Positive

The 8 way connector of the radio set is located in the front roof lamp.

IMMOBILISATION POINT

Fuel pump

Cut the BROWN/WHITE wire located in the white connector of the right lower part of

the fuse box.

STARTER

+50: Cut the wire located at the position marked “+50” in the wiring harness coming

out of the connector of the ignition key.

BONNET SWITCH

Install an additional switch on the front headlamp support plate, driver’s side.

DOORS SWITCH

Connect to the BROWN/BLACK wire at the position nr. 2 (ant. left) and to the

BROWN/GREY wire at the position nr. 3 located in the 18 way connector, on the

coming out of the ABI central, behind the glove compartment, passenger’s side.

BOOT SWITCH

Connect to the BLACK/VIOLET wire directly on the coming out of the connector of

the rear boot lamp.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

fibro01gbbt.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: