antony waistcoat instructions.pdf

URBAN Bliss Design

Men’s Waistcoat/Vest

Small measures US 34-36 chest

Medium measures US 38-40 chest

Large measures US 42-44 chest

Small 45”/115cm lining 1 ½ yds, 22”/56cm interfacing 1 5/8 yds, 45”/115cm fabric ¾

yds

Medium 45”/115cm lining 1 ½ yds, 22”/56cm interfacing 1 5/8 yds, 45”/115cm fabric

7/8 yds

Large 45”/115cm lining 1 7/8 yds, 22”/56cm interfacing 1 5/8 yds, 45”/115cm fabric 7/8

yds

You will also need four 5/8” buttons, one 1” buckle (without prong)

Good fabrics to use gabardine, brocade,satin and jacquards

For the lining cotton or polyester is good.

INTERFACING

Trim corners from interfacing at neck line and bottom point. Fuse interfacing to the

wrong side of each side of matching fabric section.

FRONT & BACK Stitch centre seam of the two back sections from upper edge to

circle. (Remaining

back pieces will be used as lining). Cut back belt into two pieces along cut off line

indicated on pattern forming right and

left back belt. For right belt, fold shorter belt in half lengthwise, right sides together,

trim seam

allowances, turn right side out, then press. Slip one short end of right belt through

buckle. Turn under 1-1 ½ “ (3.8cm) on raw

edge. Turn under again ¼” (6mm) and hand sew in place. With right sides together, pin

right belt to right side of back between squares, having

raw edge extending 5/8” (1.5cm) from raw edge. Cut seam allowances to ¼” (6mm) from

stitching, being careful not to cut back. Turn belt toward centre back, covering raw edges.

Edge stitch along seam For left belt, fold longer belt in half lengthwise, right sides

together, stitch, leaving one

short end free, trim seam allowances. Turn right side out and press. With right sides

together, pin left belt to left side of back between squares, having raw

edge extending 5/8” (1.5cm) beyond solid line toward centre back and seam

downward. Stitch 5/8” (1.5cm) from raw edge.

Cut seam allowances to ¼” (6mm) from stitching, being careful not to cut back. Turn

belt toward centre back, covering raw edges. Edge stitch, along seam. Stitch the back to

the fronts at shoulders

LINING

Stitch centre seam of back lining, from upper edge to circle Stitch front lining to back

lining at shoulders. Pin lining to vest, right sides together matching notches, circles,

centres and shoulder

seams. Stitch lower, front and neck edges, breaking stitching at circles. Stitch armhole

edges.

Turn right side out, bringing both fronts through one shoulder and out through one side

of back and press.

Starting 2” (5cm) above armhole seam and ending 2” (5cm) below seam at lower edge,

stitch back to front at sides and lining edges together in one continuous seam.

Finger press seam allowances open. Slip seam allowances under lining. Turn under 5/8”

(1.5cm) on side opening edges of lining and slipstitch together.

BUTTONHOLES AND BUTTONS Make buttonholes in left front at markings. Lap

left front over right, matching centres. Mark and sew buttons under buttonholes. And

there you have it one mans waistcoat/vest

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: