DL_Top_130_05_2007EN.pdf

burda Download Pattern

130 Top and Belt – Instructions

Burda sizes 36, 38, 40, 42, 44

exactly on seam line. Press allow-

ance on upper back edge to the

inside. Working from the right side

and using the twin needle, stitch

1 cm ( 3 ⁄ 8 ") from fold, thereby catch-

ing allowance.

Materials:

Stretch jersey, 135 cm (53") wide:

sizes 36, 38: 1.35 m (53"),

sizes 40, 42, 44: 1.40 m (55").

Vilene Bias Tape.

Twin needle.

Recommended fabrics:

Stretch jersey. Use only jerseys with

two-way stretch.

Paper pattern:

The pattern pieces are printed on

12 sheets, each framed by a thin

line. Wait until all of the sheets

have been printed. Lay the sheets

in the correct positions (see extra

sheet with the overview of the

printed sheets). Cut each sheet

along the thin lines at the top and

right edges. Begin with the lower

left sheet and glue all sheets

together, exactly on the thin lines

Now cut out the pattern pieces.

Important: Seam and hem allow-

ances are not included on the pat-

tern pieces.

Cutting:

Seam and hem allowances:

1.5 cm ( 5 ⁄ 8 ") on seams and edges

and 4 cm (1 5 ⁄ 8 ") for hem.

1 Front with strap,

on fold

Turn hem allowance to inside.

Working from the right side and

using the twin needle, stitch 3 cm

(1 1 ⁄ 4 ") from fold, thereby catching

hem.

Please note: Stitch seams with a

special stretch stitch or with a nar-

row zigzag stitch. Stitch hems with

a twin needle to maintain elasticity.

Fold belt piece in half lengthwise,

right side facing in. Stitch long

edges together, leaving 5 cm (2")

unstitched at each end. Press seam

open (on the edge of the ironing

board). Turn belt right side out.

Stitch narrow edges together,

right sides facing. First stitch 8 cm

(3 1 ⁄ 4 "), then leave approx. 5 cm (2")

open before ﬁnishing seam. Pull

the open long edges through this

opening to the outside. Stitch the

open long edges together, then

push them back in place again.

Sew remaining seam opening closed

by hand or edgestitch it closed, by

machine.

On armhole edges of back piece,

press allowance to wrong side.

Working from right side and using

twin needle, stitch 1 cm ( 3 ⁄ 8 ") from

edges, thereby catching allowances.

Finish lower edge of facing. Lay

facing on front and straps, right

sides together. Stitch together

along armhole edges, strap edges,

and front neck edges, leaving nar-

row edges of straps open. Trim

seam allowances. Clip allowances

into corner at center front. Turn

facing to inside. Press edges.

Lay back on front, right sides

facing. Pin side seam edges to-

gether, making sure to not catch

facing. Pin facing to side seams

edges, over the back piece. Stitch

side seams. Lay facing on inside of

front again.

Cutting layout

Stretch jersey, 150 cm wide

Facing, on fold

2 Back, on fold

a) Belt, in following lengths:

size 36, 66 cm (26"); size 38, 70 cm

(27 1 ⁄ 2 "); size 40, 74 cm (29"); size 42,

78 cm (30 3 ⁄ 4 "); size 44, 82 cm (32 1 ⁄ 2 "),

all 36 cm (14 1 ⁄ 4 ") wide, ﬁnished

width 18 cm (7 1 ⁄ 8 ").

Iron Vilene Bias Tape to neck and

strap edges.

Knot straps as illustrated. Try

top on to check and mark the

exact length of the straps. Gather

back ends of straps to 4 cm (1 5 ⁄ 8 ")

wide, above and below markings.

Pin straps to upper back edge, be-

tween markings. Stitch in place

Fold fabric as shown in

diagram, right side facing

in.

Key to terms:

Stoffbruch = fold

Webkante = selvage

Fadenlauf = straight grain

Vorderteil = front

Rückenteil = back

Besatz = facing

All models, pattern pieces, and illustrations are copyrighted. Commercial use is prohibited.

The publishers cannot be held responsible for damages due to improper use of the pattern or materials,

improper carrying-out of instructions or tips, or improper use of ﬁnished models.

Sewing:

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: