VOPAS98GBB.PDF

SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00

www.cobra.it

MAKE VOLKSWAGEN MOD. PASSAT 1.8 YEAR 98 ﬁ

PETROL

DIESEL

ALARM/SIREN

POSITION

Position the compact alarms and the sirens inside the wheelhouse, drivers side,

using the original support. It is necessary to remove the plastic covering. To run

the cables use one of the two original rubber grommets in the wheelhouse.

POWER SUPPLY

+ 30: connect with an eyelet terminal to the pin marked “+30” of the terminal strip

located on the lower part of the fuse box.

- 31: connect with an eyelet terminal on the grounding shunt up on the side of the

fuse box.

IGNITION WIRE

+ 15/54: connect to the 1 mm 2 BLUE/BLACK wire located in the wiring harness

coming out of the connector nr. 15 in the support of the connector behind the left

lateral bulkhead, drivers side.

DIRECTION INDICATORS

Connect to the 1 mm 2 GREEN/BLACK and WHITE/BLACK wires located in the

wiring harness coming out of the connector nr. 12 in the support of the connector

behind the left lateral bulkhead.

ELECTRIC WINDOWS

Comfort closing

Negative control signal

The total closure is obtained extending the pulse of the door locking making the

connection to the 1 mm 2 BROWN/BLUE wire.

CENTRAL DOORS LOCKING

Negative control signals

Connect to the 1 mm 2 BROWN/BLUE wire (lock) and 1 mm 2 BROWN/GREEN

(unlock) in the wiring harness of the black connector coming out of the central

doorr locking unit located under the mat on front to the left seat.

Note: for the closing it is necessary to insert a 180 ohm resistance on the

ORANGE wire (opening unit) of the antitheft.

IMMOBILISATION POINT

Fuel pump

Cut the 1,5 mm 2 YELLOW/GREEN wire located in the wiring harness coming out

of the 6 way BLUE/VIOLET connector located behind the left lateral bulkhead.

BONNET SWITCH

Install an additional switch on the front headlamp support plate, just by the

headlamp on the left-hand side.

DOORS SWITCH

Connect to the 1 mm 2 BROWN/WHITE wire located in the wiring harness and

coming out of the connector nr.6, the first on top to the connector behind the left

lateral bulkhead, drivers side.

BOOT SWITCH

Connect to the 1 mm 2 BROWN/BLACK wire located in the wiring harness and

coming out of the connector of the central door locking unit.

Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed

as per the instructions given on the product installation manual.

vopas98gbb.doc

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: