exj_8ea.pdf

INSTRUMENT PANEL SYSTEMS

8E - 1

INSTRUMENT PANEL SYSTEMS

TABLE OF CONTENTS

page

REMOVAL AND INSTALLATION

HEADLAMP LEVELING SWITCH..............1

REAR FOG LAMP SWITCH..................1

REMOVAL AND INSTALLATION

INSTALLATION

(1) Install the instrument panel center bezel on

the I. P. Be certain headlamp leveling switch electri-

cal harness is inserted through the hole in center

bezel.

(2) Connect the headlamp leveling switch electri-

cal.

(3) Verify switch / system operation.

(4) Install

HEADLAMP LEVELING SWITCH

REMOVAL

the

headlamp

leveling

switch

the

instrument

panel

center

bezel

gently

pushing

straight in.

(5) Connect the negative battery cable.

REAR FOG LAMP SWITCH

WARNING: ON VEHICLES EQUIPPED WITH AIR-

BAGS, REFER TO GROUP 8M - PASSIVE

RESTRAINT SYSTEMS BEFORE ATTEMPTING ANY

STEERING WHEEL, STEERING COLUMN, OR

INSTRUMENT PANEL COMPONENT DIAGNOSIS OR

SERVICE. FAILURE TO TAKE THE PROPER PRE-

CAUTIONS COULD RESULT IN ACCIDENTAL AIR-

BAG

DEPLOYMENT

AND

POSSIBLE

PERSONAL

INJURY.

(1) Disconnect

and

isolate

the

battery

negative

cable.

(2) Using a trim stick or another suitable wide

flat-bladed tool, gently pry the instrument panel cen-

ter bezel away from the instrument panel to release

the six snap clip retainers.

(3) Remove the center bezel from the vehicle.

(4) Remove the three screws that secure the acces-

sory switch bezel to the instrument panel

(5) Pull the accessory switch bezel out from the

instrument panel far enough to unplug the wire har-

ness connectors (Fig. 2).

(6) Remove the accessory switch bezel from the

instrument panel.

(7) Carefully pry the snap retainers at the top and

bottom of the rear fog lamp switch receptacle on the

back of the accessory switch bezel with a small thin-

bladed screwdriver and pull the switch out of the

receptacle.

Fig. 1 Headlamp Leveling Switch Position &

Orientation

1 – INSTRUMENT PANEL CNETER BEZEL

2 – HEADLAMP LEVELING SWITCH

(1) Disconnect

and

isolate

the

negative

battery

cable.

(2) Using a trim stick or another suitable wide

flat-bladed tool, gently pry the instrument panel cen-

ter bezel away from the instrument panel to release

the four snap clip retainers (Fig. 1).

(3) Pull the center bezel away from the instrument

panel far enough to disconnect the wiring harness

from the headlamp leveling switch.

(4) Depress the switch retaining tabs to remove

the switch from the center bezel.

8E - 2

INSTRUMENT PANEL SYSTEMS

REMOVAL AND INSTALLATION (Continued)

receptacle on the back of the accessory switch bezel

are fully engaged. Tighten the mounting screws to

2.2 N·m (20 in. lbs.).

Fig. 2 Accessory Switch Bezel Remove/Install

1 – ACCESSORY SWITCH BEZEL

2 – SCREW

(8) Reverse the removal procedures to install. Be

certain that both of the switch snap retainers in the

Plik z chomika:

Inne pliki z tego folderu:

Inne foldery tego chomika: